YS-3600 Precision Scribing Machine Technical Protocol

1,Equipment use environment requirements and technical parameters

YSL3600 Precision scribing machine single axis efficient cutting mode;the maximum processing Work piece size is 150*150mm,suitable for small packaging substrate materials,soft materials cutting,manual loading and unloading,automatic transmission and positioning,automatic alignment cutting.

1.The scribing machine shall be installed without obvious vibration. Clean the room

without corrosive gas and strong magnetic field. Working temperature is between 20 and 25

℃ and remains constant; relative humidity is <60%, no condensation.

2.The compressed air used by the scribing machine should be clean without oil and water,and the compressed air must be filtered through the cold dryer.

3.The cutting cooling water quality of the cutting machine shall be clean without impurities, and the water temperature shall be within 16-20℃, and the water temperature fluctuation is less than or equal to ± 1℃; the excessive water temperature may cause cutting edge breaking, membrane wear, blade and cutting; the water temperature of the cutting machine shall be within 9-16℃, and the water temperature fluctuation is less than or equal to ± 2℃; the excessive water temperature may cause tin melting, reverse cutting and broken cutting.(The difference from room temperature is within ± 3℃ to avoid excessive condensate)

4.The water quality of the spindle cooling water used in the scribing machine should be clean and free of impurities, the water temperature should be within 12-20℃, and the water temperature fluctuation is less than or equal to ± 1℃. If the water temperature exceeds the standard, it may affect the spindle cooling, affect the accuracy and stability of the spindle, resulting in cutting deviation, poor cutting quality and other conditions.(With room temperature and cutting temperature within ± 3℃)

5.Gas source oil content is less than0.5mg/m³.

2.CUTTING SYSTEM:

3.Equipment accuracy and performance

4.Equipment key parts configuration

5,Equipment application consumables

6.Equipment standard accessories

7.Technical service and after-sales service

1.Provide a set of instruction manual and equipment quality certificate.

2.Party B shall be responsible for the after-sales maintenance and technical support of the equipment.The free warranty time of the whole machine is 18months (except for the damage caused by artificial or improper operation).

3.Technical training shall be conducted for Party A's technical personnel and operators, including basic principles and operation steps, precautions for use, rules for safe use, daily maintenance methods and application software functions.

4.Party B shall provide free technical support to Party A for a longtime.

8,Installation,commissioning and acceptance

1.Party B shal I be responsibl e for the instal Iation and commissioning of all the goods

free of charge.Party A shall be responsibl e for the infrastructure construction of the

equipment and provide necessary assistance to Party B in the installation and debugging.

Party B shall carry out the installation and commissioning within 3 days upon receipt of

the notice from Party A.

2.The equipment acceptance shall be conducted by Party A.After the acceptance,

representatives of both parties shall sign on the acceptance report for confirmation.

9,Packaging and transportation

Party A(seal):

Authorized Representative (Signature):

Time of contract:

Party B(seal):

Dongguan Yushunli Automation Equipment Co.,Ltd

Authorized Representative (Signature):

Time of contract